I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters, please follow the steps below.

Put the adapters on a power strip

Connect the adapters one after the other to a power strip.

Connect the adapters to the Internet

Connect each adapter to a working device (internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be a communication between the devices otherwise the adapter will automatically go into standby mode.

Press the Connect & Secure button (first adapter)

Once the adapter is plugged in and connected to the Ethernet, simply press the “Connect & Secure” button on the front panel for 10 seconds.

Press the Connect & Secure button (second adapter)

Press the “Connect & Secure” button on the front panel of the second device for 10 seconds. You have up to two minutes to do it.

Home LED blinks

The home LEDs should start blinking.

Adapters are reset

All the LEDs must be green at the end of the operations.

Repeat the same operation for a third powerline. You can have up to eight Powerline 600 on the same electrical installation.
After resetting all the devices, you can put them in the room where you need them.

Tags:

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

1 Put the adapters on a power strip

2 Connect the adapters to the Internet

3 Press the Connect & Secure button (first adapter)

4 Press the Connect & Secure button (second adapter)

5 Home LED blinks

6 Adapters are reset

Menu