I cannot find my existing Wi-Fi network in the installation wizard of the repeater, why?
I cannot find my existing Wi-Fi network in the installation wizard of the repeater, why? It is very likely that your repeater is too far from your modem/router. We recommend configuring your repeater in the same room as your modem/router and then changing its location to a different room.
How do I connect to the Web UI after setting up my device?
How do I connect to the Web UI after setting up my device? 1 Connect your repeater Wi-Fi Network You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. . 2 Browse to the Web UI URL Type the URL in […]
Can I deactivate the LEDs of my repeater ?
Can I deactivate the LEDs of my repeater ? Yes to deactivate the LEDs of your repeater you just have to use th switch on theright side of the product.
I cannot access the Web UI with the URL (http://strong.ap750) during the configuration, why?
I cannot access the Web UI with the URL (http://strong.ap750) during the configuration, why ? During the configuration of the repeater, you must connect directly to the IP Address of your repeater
I cannot access the Web UI (http://strong.ap750) after setting up my repeater, why?
I cannot access the Web UI (http://strong.ap750) after setting up my repeater, why?
How do I connect to the WPS?
How do I connect to the WPS? 1 Activate the WPS on your repeater To activate the WPS, press the button located on the front side of your repeater for 2 seconds, to connect your computer to the repeater or for 6 seconds, the repeater will connect to your router/AP. 2 Activate the Wi-Fi and […]
How do I activate the WPS?
How do I activate the WPS? To activate the WPS, press the button located on the left side of your repeater from approximately 5 seconds (until the WPS LED is flashing). If you press the WPS button for 2 seconds, you will be able to connect your computer to the repeater If you press the […]
Where can I find the Wi-Fi Network Information of my repeater?
Where can I find the Wi-Fi Network Information of my repeater? You can find the information for the Wi-Fi Network on the product label, located under your repeater.
What do the LEDs on the repeater mean?
What do the LEDs on the repeater mean? Lorem ipsum dolor sit amet, consectetur adipisicing elit. Culpa enim esse excepturi nemo nesciunt officia officiis optio.
What is the best location for my repeater?
What is the best location for my repeater? Your repeater should not only be near to your modem/router, but also to a Wi-Fi dead zone. By doing so, your repeater will pick up the signal from the modem/router and repeat it to extend the coverage of your Wi-Fi Network.
