Can I configure a Guest Network for my Mesh network? (Case 2: App)
Can I configure a Guest Network for my Mesh network? (Case 2: App) Yes, you can configure a Guest Network for your Mesh network. 1 Access the App To connect to the App, please refer to the following procedure: How do I use the Atria Mesh App? 2 Guest Wi-Fi Click Guest Wi-Fi. 3 Activate […]
Can I configure a Guest Network for my Mesh network? (CASE 1: Web UI)
Can I configure a Guest Network for my Mesh network? (Case 1: Web UI) Yes, you can configure a Guest Network for your Mesh network. 1 Access the Web UI To connect to the Web UI, please refer to the following procedure: How do I access the Web UI? 2 Wi-Fi Settings Click Wi-Fi in […]
How many Wi-Fi networks are provided with my Mesh unit?
How many Wi-Fi networks are provided with my Mesh unit? Your Mesh network only has one main Wi-Fi network once the mesh agents and controller are paired together.If you need to have additional Wi-Fi networks, you can configure Guest Wi-Fi networks.For the mesh 1200, you can configure two guest networks, one for the 2.4G band […]
I cannot access the internet after configuring my Mesh network,why?
I cannot access the internet after configuring my Mesh network, why? There are several reasons why you cannot access internet after configuring your Mesh Network: The RJ45 cable is not properly connected to the internet box or the main Mesh or in the wrong port.The internet connexion from the internet box is not working properly. […]
How do I reset my Mesh units to the factory settings? (CASE 2: Web UI)
How do I reset my Mesh units to the factory settings? (CASE 2: Web UI) 1 Access the Web UI To connect to the Web UI, please follow this procedure : How do I access the Web UI? 2 System Settings Click System in the left bar. 3 Restore to factory Settings Click Restore Factory. […]
How do I reset my Mesh units to the factory settings? (CASE 1: Button)
How do I reset my Mesh units to the factory settings? (CASE 1: Button) 1 Reset Button To reset your device to its factory settings, please press the reset button with a paper clip for at least10 seconds. 2 LEDs Then, you must wait for the LED to turn off and turn back on.
How do I use the WPS function?
How do I use the WPS function It is very easy to activate the WPS on your router. 1 Activate the WPS on your main mesh unit To do so, press the WPS button on the Mesh unit that is connected to your router/modem by RJ45. 2 Internet Settings Now go the the Network selection […]
How do I update the firmware of the Mesh unit?
How do I update the firmware of the Mesh unit
How can I access the Web UI of the different Mesh units?
How can I access the Web UI of the different Mesh units? 1 Connect to the Wi-Fi of the mesh Connect to the Wi-Fi of the main mesh unit. 2 Browse to the Web UI IP Address Then, you must browse to the Web UI IP address 3 Easy mesh Settings Click on Easy Mesh […]
Where can I find the credentials to access the Web UI?
Where can I find the credentials to access the Web UI? The credentials to access the Web UI are located under your Mesh 1200. By default, the Username and Password for the Web UI are “admin”. To connect to the Web UI and change the administration password, please refer to : How do I access […]
