How do I reset my repeater to its factory settings? (Reset Button)
How do I reset my repeater to its factory settings? (Reset Button) Press the reset button located on the left side of the repeater until the LEDs are off. The device will turn back on automatically once it is reset.
How do I reset my repeater to its factory settings? (Web UI)
How do I reset my repeater to its factory settings? (Web UI) 1 Connect your repeater with a RJ45 cable You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. 2 Browse to the Web UI URL Type the URL in […]
I configured my repeater as an extender, but my broadband internet speed is not improved, why?
I configured my repeater as an extender, but my broadband internet speed is not improved, why? Repeaters can improve the Wi-Fi coverage, performance and connectivity locally but the broadband Internet speed is defined by your subscription of your Internet Service Provider.
I have a guest network on my modem/router. Can I extend my router’s network as well as the main Wi-Fi Network with the repeater,
I have a guest network on my modem/router. Can I extend my router’s network as well as the main Wi-Fi Network with the repeater, It is not possible to extend two Wi-Fi Network. You can extend either your Guest Network or your main Wi-Fi Network.
I cannot find my existing Wi-Fi network in the installation wizard of the repeater, why?
I cannot find my existing Wi-Fi network in the installation wizard of the repeater, why? It is very likely that your repeater is too far from your modem/router. We recommend configuring your repeater in the same room as your modem/router and then changing its location to a different room.
How do I connect to the Web UI after setting up my device?
How do I connect to the Web UI after setting up my device? 1 Connect your repeater Wi-Fi Network You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. . 2 Browse to the Web UI URL Type the URL in […]
Can I deactivate the LEDs of my repeater ?
Can I deactivate the LEDs of my repeater ? Yes to deactivate the LEDs of your repeater you just have to use th switch on theright side of the product.
I cannot access the Web UI with the URL (http://strong.ap750) during the configuration, why?
I cannot access the Web UI with the URL (http://strong.ap750) during the configuration, why ? During the configuration of the repeater, you must connect directly to the IP Address of your repeater
I cannot access the Web UI (http://strong.ap750) after setting up my repeater, why?
I cannot access the Web UI (http://strong.ap750) after setting up my repeater, why?
How do I connect to the WPS?
How do I connect to the WPS? 1 Activate the WPS on your repeater To activate the WPS, press the button located on the front side of your repeater for 2 seconds, to connect your computer to the repeater or for 6 seconds, the repeater will connect to your router/AP. 2 Activate the Wi-Fi and […]
