How do I update the firmware of my repeater?
How do I update the firmware of my repeater? 1 Browse to the download section on https://www.strong-eu.com/ Before the update, you must go to the download section of our website to see if there is a new software version available. 2 Download To access the downloads, Click Assistance and Download in the top bar and […]
How do I reset my repeater to its factory settings? (Reset Button)
How do I reset my repeater to its factory settings? (Reset Button) Press the reset button located on the left side of the repeater until the LEDs are off. The device will turn back on automatically once it is reset.
How do I reset my repeater to its factory settings? (Web UI)
How do I reset my repeater to its factory settings? (Web UI) 1 Connect to Wi-Fi or Internet Network of your repeater You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. 2 Browse to the Web UI Browse to the […]
I configured my repeater as an extender, but my broadband internet speed is not improved, why?
I configured my repeater as an extender but my broadband internet speed is not improved, why? Repeaters can improve the Wi-Fi coverage, performance and connectivity locally but the broadband Internet speed is defined by your subscription of your Internet Service Provider.
I have a guest network on my modem/router. Can I extend my router’s network as well as the main Wi-Fi Network with the repeater?
I have a guest network on my modem/router. Can I extend my router’s network as well as the main Wi-Fi Network with the repeater, It is not possible to extend two Wi-Fi Network. You can extend either your Guest Network or your main Wi-Fi Network.
How do I connect to the Web UI after setting up my device?
How do I connect to the Web UI after setting up my device? 1 Connect to the Wi-Fi or the Internet network of the repeater You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. 2 Browse to the Web UI […]
Can I deactivate the LEDs of my repeater ?
Can I deactivate the LEDs of my repeater ? 1 Connect to the Wi-Fi or the Internet network of the repeater You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration. 2 Browse to the Web UI Enter the URL of […]
I cannot access the Web UI with the URL (http://setup.strong) during the configuration, why ?
I cannot access the Web UI with the URL (http://setup.strong) during the configuration, why ? During the configuration of the repeater, you must connect directly to the IP Address indicated on the product label of the repeater.
I cannot access the Web UI (http://setup.strong) after setting up my repeater, why?
I cannot access the Web UI (http://setup.strong) after setting up my repeater, why?
How do I connect to the WPS?
How do I connect to the WPS? 1 Press the WPS button of the repeater To activate the WPS, press the button located on the left side of your repeater from approximately 5 seconds (until the WPS LED is flashing). 2 Press the WPS Button of your router Press the WPS of your Internet box/router […]
